What type of cable is required to connect to the Trig in/out and Signal in/out connections on my TLA711/TLA720/721 controller?

Question:

What type of cable is required to connect to the Trig in/out and Signal in/out connections on my TLA711/TLA720/721 controller?

Answer:

The connectors used on these mainframe controllers are SMB’s. A P6041 probe was included as a standard accessory. It is approximately 40” long and has a SMB connector on one end and a BNC connector on the other.

This FAQ Applies to:

Product: TLA711, TLA721

FAQ ID : 64266

View all FAQs »
Загрузки
Загрузить

Загрузить руководства, технические описания, программное обеспечение и т. д.:

Go to top