Вопрос :
Using the HT3 software+ I couldn't connect the AWG and DTG+ when I click the test connection the "Connection failure" message box is appears. What can I do?
Ответ :
Following tips helps to troubleshoot the test setup:
Check the AWG and DTG’s GPIB connection
Check the GPIB bus timing value in the NI Measurement Automation explorer.
Try communicating to the device using the NI Measurement automation explorer.
Check the NI driver’s installation.
Эти часто задаваемые вопросы относятся к
Серия приборов не найдена
Прибор:
Идентификатор часто задаваемых вопросов 59861
Просмотреть все ЧЗВ »